Operation Using Multiple Remote Controls - Window Master WIC 01M Instructions D'installation

Operation using multiple remote controls

Each WIR 100 remote control can be configured to operate any number of WIC 01M. And multiple WIR 100 remote
controls can be configured to operate the same product(s).
On the figure below a system consisting of two WIR 100 and three WIC 01M is shown. One remote control is configured
to operate all the WIC 01M while the other remote control only operates one WIC 01M.
A
1
In this setup remote control 2 operates all three WIC 01M simultaneously. Remote control 1 is configured to control WIC
01M A only. The procedure to achieve this configuration is described below.
Connect WIC 01M A to mains supply. (NB: Do only connect voltage to this
1.
one WIC 01M at this point!)

WIC 01M A is now in registration state for 10 minutes or until it is
registered.
Press the reset-button shortly on remote control no. 1.
2.

Now WIC 01M A is operable by remote control no. 1.
Keep down the reset-button of remote control 1 for approximately 10 seconds.
3.

Now WIC 01M A is ready to be registered by additional remote controls.
Connect WIC 01M B and C to mains supply.
4.

Now these two units are ready for registration.
Press the Reset-button on remote control no. 2 for 1 second.
5.
Now the registration is completed and the configuration illustrated is completed.
If a two-way VELUX KLR 100 remote control is present it is recommended that all products are registered in this as a
starting point. Subsequently it is possible to register the individual products in one or more one-way remote controls
using a special function of the two-way remote controls. For a detailed explanation of how to do this see the manual of
the VELUX KLR 100.
B
2
7
C