Camera Test Connector Detail; Monitor Installation - Fermax VideoChalet Citymax 1/L Mode D'emploi

Camera Test Connector detail

The test connector included in the CityMax camera is used for testing that
both camera and Monitor are working correctly. Once the Monitor is plugged
into this connector the screen will be activated automatically.
1. TEST connector Detail.

MONITOR INSTALLATION

The CityMax monitors allow a quick and easy installation, without neccesity
of doing any kind of building-work. Do not remove the screen protection film until
the Monitor is completely installed.
1. Use a plain screw-driver to separate the
base from the Monitor. Put it in, rotate
and slide the Monitor up.
Pag 20
2. Monitor Test directly in the Outdoor
Panel.
2. Install the Monitor on a hard and flat
surface. Mark and drill the wall at the
holes in the base.