Joie i-Snug Mode D'emploi page 13

Use with Strollers
see images -
40 49
Your infant carrier module is designed to attach to certain Joie
stroller models featuring a special tray, armbar or calf support.
!
Please make sure your stroller can fit the infant carrier
module before purchasing it.
!
Never allow more than one baby in the travel system at
one time.
!
Please brake your stroller before assembling the infant
carrier module.
!
Check that the parts used to fix the infant carrier module
are securely fastened on the stroller.
!
Recline the stroller seat back to the lowest position.
Use with Joie Strollers
To assemble the infant carrier module on Joie strollers, please
follow these steps:
1. Place infant carrier module into stroller so notches in rockers
fit over edge of armbar, tray or calf support. The infant carrier
module will then automatically click into place.
43
!
If armbar has fabric cover, please detach the Velcro on
armbar cover first. -1
42
!
For the stroller with a special calf support, please adjust
the calf support to the vertical position, detach the
Velcro, and then lift the fabric cover.
23
& & &
40 41 42
-1
43
40
42
1
2. Use the straps on both sides of stroller to fix the child
restraint. & &
44 45 46
!
Try pulling the child restraint upwards to check that it is
fitted correctly.
To remove the infant carrier module, release the straps from
the infant carrier module, pull up the stroller release handle to
release the infant carrier module from tray, armbar or calf
support, and then lift infant carrier module out of stroller.
Please refer to & & .
47 48 49
41
43
1
24