Elesa MPI-15 Manuel D'utilisation page 17

Parameter Description
Direct reference value
ProGOrG
setting
Direct offset value
ProGOFS
setting
Language
LanG
Sensor calibration
SEtUP
procedure
Reset parameters to
dEFAULt
factory value
Software release
reL
ELESA models all rights reserved in accordance with the law. Always mention the source when reproducing our drawings.
Available options
The parameter allows enabling the direct reference value setting procedure.
Use and to choose between:
: in the operating mode the parameter
EnAbLE
by pressing +
: the parameter
diSAbLE OriGin
the programming mode.
The parameter allows enabling the direct offset value setting procedure.
Use and to choose between:
: in the operating mode the parameter
EnAbLE
by pressing +
: the parameter
diSAbLE OFFSEt
the programming mode.
The parameter allows selecting the language.
Use and to choose between:
ItALiAn
ENGLiSH
dEutSCH
The parameter allows running the calibration procedure.
Press to start the procedure. See Par. 7 for detailed procedure description.
Press to reset the parameters.
A confirmation message is displayed: press
The software release is displayed.
Magnetic length and angle measuring system MPI-15
can be modified
OriGin
can be modified only by entering
can be modified
OFFSEt
can be modified only by entering
to confirm, to exit the procedure.
Std Value
diSAbLE
diSAbLE
ItALiAn
E02
17