Clatronic HTD 2940 Mode D'emploi & Garantie page 24

GB
1. Fully unwind the mains cable.
2. Fit on a nozzle. You can dry single hair locks by concentrating the fl ow of hot
air with the hairdressing nozzle. The diffuser is the ideal solution to dry curly
hair without losing volume.
3. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
4. Setting the Temperature Level (right switch):
Position 1:
Position 2:
Position 3:
Setting the desired blower strength (left switch):
Position 0:
Position 1:
Position 2:
COOL-Shot:
TURBO button: By pressing the turbo button you can increase the air cur-
• Before cleaning remove the mains lead from the socket.
• Clean the housing with a soft, dry cloth without additives.
Air Intake Grill
• Please clean the grill on the air intake side of the hairdryer regularly in order to
avoid excessive temperatures as a result of heat accumulation.
• To do so, please remove the cover of the grill by means of the recess on the
top of the hairdryer.
• Remove any dirt that is present. If necessary, a fi ne brush can be used. Then
close the cover again carefully.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
24
6....-05-HTD 2940 24
Commissioning
cold air
medium temperature for gentle drying and shaping
high temperature for rapid drying
OFF
gentle stream of air
strong stream of air
With this switch it is possible to interrupt the heating
process so that the air can be mixed according to individual
requirements.
rent even further.
Cleaning and care
01.12.2004, 10:05:17 Uhr