Yamaha E40X Manuel D'utilisation page 136

q
w
605024
q
605014*
4-6
EMK21510
8 Flushing in a Water Tank
1) Install the outboard motor on the
water tank.
2) Fill the tank with fresh water to above
the level of the anti-cavitation plate.
3) Shift into neutral and start the engine.
4) Run the engine at low speed for a few
minutes.
cC
If the fresh water level is below the level
of the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
1 Water surface
2 Lowest water level
EMK21210
8 Flushing with the Flushing Attachment
w
Before using the flushing attachment,
remove the propeller. Keep yourself and
others away from the propeller shaft.
1) Fit the flushing attachment 1 (option)
in position on the lower casing, with
rubber cups covering the cooling
water inlet.
2) Connect a garden hose between the
flushing attachment and the water
tap.
3) Shift into "NEUTRAL", and start the
engine while supplying water.
4) Run the engine at low speed for a few
minutes.
E