Teaching-In On The Max! System; Teach-Out/Reset - eQ-3 MAX! Mode D'emploi

7. Teaching-in on the MAX! system

In order to enable communication
between MAX! Components, the
devices have to be taught-in to
one another.
Start by switching the teach-in
•
partner (e.g. the MAX! Cube) to
teach-in mode.
To activate teach-in mode on the
•
MAX! Window Sensor, press and
hold down the teach-in button (3).
The device LED starts to flash.
Successful teaching-in of the
•
MAX! Window Sensor is confirmed by the LED light-
ing up once.
The radio-controlled window sensor can only be
taught in on one device (e.g. the MAX! Cube)
The MAX! Window Sensor can be reset to the initial state
manually. Restoring the initial state deletes all settings and
information about taught-in devices.
• First remove the batteries from the electronic unit.
Wait 60 seconds.
•
Press and hold down the teach-in button.
•
• Then re-insert the batteries.
• Press and hold down the teach-in button until the LED
starts to flash.
Release the teach-in button; the factory settings are
•
restored.

8. Teach-out/Reset

19