Inserting (Replacing) Batteries - eQ-3 MAX! Mode D'emploi

Screw fastening damages the window frame. For
those living in rented accommodation, this could
lead to a landlord making a claim for compensation or
holding back a tenant's deposit.

6. Inserting (replacing) batteries

The window sensor runs on 2 LR03
(micro/AAA) batteries.
Remove the cover on the electronic unit
•
by pulling it forward and off the device
(1). To release the cover, squeeze it gently
from above and below with your thumb
and index finger (4).
• Carefully lift the release clip (2) from
the side.
Pull the electronic unit forward (3) and
•
off the bracket.
• After removing the old batteries, please
wait approximately 60 seconds before
inserting the new ones.
I n s e r t 2 n e w L R 0 3 (m i c r o /A A A )
•
batteries in the battery compartment
(making sure that you insert them the
right way round).
Place the electronic unit back onto the
•
bracket, allowing it to latch into place.
• Screw the cover back onto the unit. Make sure that the
LED opening on the cover is positioned over the LED on
the electronic unit.
Never recharge standard batteries. Doing so
will present a risk of explosion. Do not throw the
batteries into a fire. Do not short-circuit batteries.
18