Display Of The Results; For 2 Limits - KERN PES 220-3M Mode D'emploi

There are two different ways to set the tolerance limits:
1. Place the values (object) on the balance -
2. Numeric entering of values -
NOTE:
 If a limiting value was set it remains saved until the balance is turned off.
 For the functions weighing, counting, percent individual limits can be set.
 When entering the limits please pay attention to the type of evaluation that was set.

12.2. Display of the results

12.2.1.

For 2 limits

The triangular tolerance marker ( ) in the upper part of the display shows whether
the goods to be weighed are within the two tolerance limits.
The tolerance marker is only in operation during operating mode tolerance weighing;
it is otherwise not visible.
The tolerance marker provides the following information:
Display If a point is set as lower
Result
No display
+ (high)
Lower limit ≤ Weight
TOL  (OK)
- (low) Lower limit > Weight
58
> Save this value
> Enter the limits via keyboard.
Goods to be weighed above tolerance limit
Goods to be weighed within tolerance range
Goods to be weighed below tolerance limit
If two points are set as upper and
limit
Weight > Upper limit
Lower limit ≤Weight ≤ Upper limit
Lower limit > Weight
lower limit
PES/PEJ-BA-e-1617