Averaging Measurement Mode - Riester ri-champion smartPRO Mode D'emploi

NOTE
• If you press
• If the pulse rate symbol is shown as "
that the meter has detected an irregular heart beat.

AVERAGING MEASUREMENT MODE

Always apply the pressure cuff before turning on the meter.
during measurement, the meter will be turned off.
1. Press and hold
''AVERAGE'', then press
"
reading will be stored in its memory. Then the
cuff will begin to inflate automatically.
2. After the first measurement is completed,
the meter will start counting down before the
second measurement begins. The number on
the right represents the remaining countdown
between each measurement. The meter will
take three (3) measurements consecutively
with intervals of 20 seconds.
3. After taking three measurements, the results
are averaged to produce the blood pressure
measurement with ''AVERAGE'' symbol
display on the meter. Press
meter.
" instead of "
until the meter displays
" (numbers from 1 to 4) whose test
12
", this indicates
to select user
to turn off the