Preparation - Beko BCH 130000 Manuel D'utilisation

4

Preparation

• Your cooler/freezer should be
installed at least 30 cm away from
heat sources such as hobs, ovens,
central heater and stoves and at
least 5 cm away from electrical
ovens and should not be located
under direct sunlight.
• The ambient temperature of the
room where you install your cooler/
freezer should at least be 10°C.
Operating your cooler/freezer
under cooler conditions is not
recommended with regard to its
efficiency.
• Please make sure that the interior
of your cooler/freezer is cleaned
thoroughly.
• If two cooler/freezers are to be
installed side by side, there should
be at least 2 cm distance between
them.
• When you operate your cooler/
freezer for the first time, please
observe the following instructions
during the initial six hours.
• The door should not be opened
frequently.
• It must be operated empty without
any food in it.
• Do not unplug your cooler/freezer.
If a power failure occurs out of your
control, please see the warnings in
the "Recommended solutions for
the problems" section.
• Original packaging and foam
materials should be kept for future
transportations or moving.
• You can load maximum amount of
food to the freezer compartment
of the cooler/freezer by removing
the freezer compartment
drawers. Declared energy
consumption value of the cooler/
freezer was determined with the
freezer compartment drawers
removed,except if available bottom
drawer and with maximum amount
of food loaded. There is no risk in
using a shelf or drawer suitable for
the shapes and sizes of the foods to
be frozen.
• Do not block the freezer fan grill by
placing foods in front.There must
always be left minimum 3 cm open
distance in front of the freezer fan
grill to allow neceserray air flow to
freeze the compartment efficiently.
• In some models, the instrument
panel automatically turns off 5
minutes after the door has closed.
It will be reactivated when the door
has opened or pressed on any key.
• Due to temperature change as
a result of opening/closing the
product door during operation,
condensation on the door/body
shelves and the glass containers is
normal
11
EN