Pioneer N-P01-S Guide Rapide page 3

Connecting playback components
Connect the network audio player and stereo receiver with the supplied remote control cable and RCA audio cable.
Stereo receiver SX-P01 or SX-P01DAB
(XN-P02, XN-P02DAB only)
1
Network audio player (N-P01)
Connecting your iPod/iPhone/iPad or USB device
Connect your iPod/iPhone/iPad or USB device to the iPod/iPhone/
iPad/USB terminal on the front panel of the network audio player.
l STANDBY/ON
5 V 2.1 A
USB cable provided with iPod/iPhone/iPad units,
or a commercially available USB cable to support
iPod/iPhone/iPad (for iPod connection)
iPod/iPhone/iPad
USB mass
storage
device
Connecting the speakers (XN-P02, XN-P02DAB only)
Be sure to complete all connections before connecting unit to the AC power source.
Right speaker Left speaker
ANTENNA
3
WLAN ANTENNA
WLAN ANTENNA
2
Supplied
WLAN antenna
WLAN ANTENNA
AUDIO DIGITAL
OUT OUT
L
LAN (10/100)
CONTROL
R
OPTICAL
OUT
N-P01
NETWORK AUDIO PLAYER
SOURCE
 
 
Make sure you connect the speaker on the
right to the right (R) terminal and the speaker
on the left to the left (L) terminal. Also make
sure the positive and negative (+/–) terminals
on the stereo receiver match those on the
speakers.
You can use speakers with a nominal
impedance between 4  and 16 .
To NETWORK IN sockets
1 3
WLAN ANTENNA
AC IN
WLAN ANTENNA
2
AC IN
Supplied
WLAN antenna
WLAN ANTENNA
AC IN
Connecting wire antenna (XN-P02, XN-P02DAB only)
Connect the FM wire antenna (XC-P01) or DAB/FM wire antenna
(XC-P01DAB) as shown below.
FM wire antenna
Modem
Internet
Router
LAN
3 2 1 WAN
To LAN
port
Computer
LAN cable
(commercially available)
To AC outlet
Power cord
Stereo receiver (XC-P01 for example)
ANTENNA
XC-P01DAB:
Connect the DAB/FM wire
antenna to the DAB/FM
socket.
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire
is twisted together and inserted fully into
the speaker terminal. If any of the bare
speaker wire touches the back panel it
may cause the power to cut off as a safety
measure.
3
En