Haussmann LS15-20 Guide De L'utilisateur page 6

glasses.
n) Secure work. Use clamps or a vise to hold work when practical,
it is safer than using your hand and frees both hands to operate the
tool.
o) Do not overreach. Keep proper footing and balance at all times.
p) Maintain tools with care. Keep tools sharp and clean for better
and safer performance. Follow instructions for lubricating and changing
accessories.
q) Disconnect tools. When not in use, before servicing, or when
changing attachments, blades, bits, cutters, etc., all tools should be
disconnected from power source.
r) Avoid accidental starting. Be sure switch is off when plugging in
any tool.
s) Never stand on tool. Serious injury could occur if the tool is
tipped.
t) Check damaged parts. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to
determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any other conditions that
may affect its operation. A guard or other part that is damaged must
be properly repaired or replaced by an authorized service center to
avoid risk of personal injury.
u) Use the right direction of feed. Feed work into the blade against
the direction or rotation of the blade, only.
v) Never leave tool running unattended. Turn the power OFF and
unplug tool. Don't leave tool until it comes to a complete stop.
w) Protect your lungs. Wear a face or dust mask if the cutting
operation is dusty.
x) Protect your hearing. Wear hearing protection during extended
periods of operation.
y) Handle cord carefully.. Never carry tool by the cord or yank it to
disconnect from receptacle. Keep cord from heat, oil, and sharp
edges.
z) Use outdoor extension cords. When tool is used outdoors,
use only extension cords with approved ground connection that are
intended for use outdoors and so marked.
aa) Never use in an explosive atmosphere. Normal sparking of the
motor could ignite fumes.
bb) Inspect tools cords periodically. If damaged, have repaired
by a qualified service technician atan authorized service facility.
The conductor with insulation having an outer surface that is green
with or without yellow stripes is the equipment-grounding conductor.
If repair or replacement of the electric cord or plug is necessary, do
not connect the equipment-grounding conductor to a live terminal.
Repair or replace a damaged or worn cord immediately. Stay
constantly aware of cord location and keep it well away from the
rotating blade.
cc) Inspect extension cords periodically and replace if damaged.
dd) Keep tool dry, clean and free from oil and grease. Always
5