Dexter power CGA18LD Manuel D'utilisation page 15

OPERATION
1. SLIDE ON/OFF SWITCH (See Fig. B)
To start the power tool, first press the back of on/off switch, then push the on/off switch (6) forward.
To lock the on/off switch (6), press the on/off switch (6) down at the front until it engages.
To switch off the power tool, briefly press down the back of the on/off switch (6) and then release it.
NOTE: The machine is equipped with the function of Accidental Start Protection.
the machine will not run when you put the battery on the machine if switch is engaged "on" position
to make sure safety to user. The machine will work only after you switching off and switching on
again.
2. HAND GRIP AREAS
Always hold your angle grinder firmly with both hands when operating.
3. ADJUSTABLE AUXILIARY HANDLE (See Fig. C)
You have the option of two working positions to provide the safest and most comfortable control of
your angle grinder. The handle can be screwed clockwise into either hole on the sides of the gear
case.
NOTE: this handle should be used at all times to maintain complete control of the tool.
4. SPINDLE LOCK BUTTON
The spindle lock button must only be used when changing a disc.
WARNING: Never press it when the disc is rotating!
5. DISC FITTING (See Fig. D, E)
The inner flange (9) is located over the spindle and check that if the inner flange is correctly located.
The two machined flat sections must face the angle grinder and located in the appropriated position
on the spindle. Locate the disc (11) onto the inner flange (9) with the label facing the angle grinder
and then place the outer flange (8) onto the spindle. Press the spindle lock button (2) and rotate the
spindle until it locks, then firmly tighten the outer flange (8) with the supplied spanner (10). Check if
the disc can rotate freely and is securely clamped. Make a no load test run for 20 seconds to check
disc vibration and disc run out. To remove a disc, reverse these instructions.
WARNING: Do not use a disc marked with a lower RPM than that of the max rated speed
shown on the rating plate. Clean the flanges and check the new disc.
6. FIX OUTER FLANGE CLAMPING (See Fig. F)
Ensure the raised part of the outer flange is fitted facing the grinding disc to provide improved
support for the disc hole. Always ensure your disc is securely clamped.
7. ADJUSTMENT AND REMOVING THE GUARD
ADJUSTING THE GUARD
Before any work on the machine itself, detach battery pack.
For work with grinding discs, the wheel guard must be mounted.
WHEEL GUARD FOR GRINDING
The coded projection on the wheel guard ensures that only a guard that fits the machine type can
be mounted.
Open the clamping lever. Place the wheel guard with coded projection into the coded groove on the
spindle of the machine head and rotate to the required position (The recommended work angel for
the guard is -30° to +30°).
To fasten the wheel guard, close the clamping lever.
The closed side of the wheel guard must always point to the operator.
EN
15