Dexter power CGA18LD Manuel D'utilisation page 14

EN
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for roughing and brushing metal and stone materials without using water.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger ACG18LD is matched to the Li-ion battery ABP118L2/ABP118L3. Do not use
another battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may become too hot to permit charging.
Allow time for the battery to cool down before recharging.
When the battery pack is charged for the first time and after prolonged storage, the battery pack will
accept a 100% charge after several charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK
Depress the Battery Pack Release Button (5) firmly first and then slide the Battery Pack out from
your tool.
C) TO INSTALL THE BATTERY PACK
Slide the fully charged Battery Pack onto the tool with sufficient force until it clicks into position.
D) HOW TO CHARGE YOUR BATTERY PACK (SEE FIG A)
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process
has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug
the charger and remove the battery pack.
WARNING: When battery charge runs out after continuously use or exposure to direct
sunlight or heat, allow time for the tool to cool down before re-charging to achieve the full
charge.
CHARGING INDICATOR
This recommended charger is designed to detect some problems that can arise with battery
packs. Indicator lights indicate problems (see table below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery charges correctly, then the original pack
is defective and should be returned to a service center or recycling service center. If the new
battery pack displays the same problem as the original Battery Pack, have the charger tested at an
authorized service center.
Light
Red on
Red flash
Green on
Green flash
14
ON/OFF flash
________
_ _ _ _
________
_ _ _ _
Status
Charging
Defective Battery
Fully Charged
Hot/Cold Delay