Setting The Time; Selecting The Language; Restoring The Factory Settings; Advanced Settings - Kerbl 345000 Mode D'emploi

In the Button menu, you can define a reset time for each
button. To do so, navigate to the "Time(min)" menu item and
press -> to change the value. Now set the desired time in
minutes using the ^ and v keys. When a button is pressed,
the selected function is executed. At the same time, the reset
time begins. After the set reset time, the button action is
reset.
If you switch the light on manually during the night, for
example, and a reset time is defined here, the light will be
switched off again when this reset time has elapsed.

9.7 Setting the time

To set the current time, navigate to "Time" in the Settings
menu. When you press <- you will see the following display:
• The hour value in the time display flashes.
Set the hour to the correct time using the ^ and v keys. Press <- to confirm.
• The minute value in the time display flashes.
Set the minute to the correct time using the ^ and v keys. Press <- to confirm.

9.8 Selecting the language

You can select the "Lang." item in the Settings menu. Here you will see a display of all the possible language settings.
Select your language using the ^ and v keys and press
<- to confirm your selection. The screen returns to the Set-
tings menu. The display will now be in your chosen lan-
guage.

9.9 Restoring the factory settings

You can restore the light control to its as-delivered state at
any time, to reset all settings to their original values. To do
so, open the Settings menu, then Setup. Here, move the
cursor to "Factory stgs". Press <- to confirm your selection.
Next, the light control restarts.

10. Advanced settings

10.1 Adapting the sensor reading

The light sensor's reading can be adapted to suit its installation location by adjusting the settings as appropriate. If the
light sensor is installed in a location with a comparatively high light incidence, you can reduce the sensor's sensitivity.
To do so, select "Sensor stgs" in the main menu. You will see the following display:
Press <- to select any circuit for setting the sensitivity. Use ^ and v to set the sensitivity of the sensor. The sensitivity value
is displayed in brackets after the current reading. It can be set in the range between 0.8 and 7.0. The higher the
sensitivity, the more sensitively the sensor reacts and the higher the displayed reading.
Time: 00 : 00
-> C I R C T 1: 49 (2.0)
C I R C T 2: 49 (2.0)
C I R C T 3: 49 (2.0)
C I R C T 4: 49 (2.0)
Back
41