Care And Maintenance - Weller Zero Smog 4V Traduction De La Notice Originale

Care and maintenance

Warning!
Before doing any work on
the machine, pull the plug
out of the socket.
Use original replacement
parts only.
treated as special waste.
Dispose of replaced equip-
devices in accordance with
the rules and regulations
applicable in your country.
Notice
constituents and the amount
of and size of dust particles
for the extraction of adhesive
fumes.
Error messages and error clearance
Message/symptom
Extraction power missing
Loud extraction noises
Zero Smog is not running
working
medium
Reset unit
24
1.800.561.8187
be replaced as follows
when indicated or
if the maximum allowable workplace concentration is exceeded or
as per maintenance schedule
once an hour
-
on after restarting the unit.
Possible cause
Turbine speed too low
Air speed through extractionarm
is too high speed
Minimum pressure hose was not
www. .com
Remedial measures
Increase the speed setting
Reduce the air speed (reduce air
Leave the Zero Smog to cool
down Switch on again afterap-
prox. 3 hours
proportion of solid matter is high.
inserted for longer than 2
and switch unit off and on again
information@itm.com
-
-