Yoo Digital Home VAPYOO 900 Mode D'emploi page 12

St EA M IRoN IN g
1. fill water tank with clean tap water refer to above filling instruction. for better performance,
please immerse filter in water for several minutes before install it into the water tank)
2. Connect the appliance into a suitable socket outlet. Press power switch on control panel, a Beep
sound will be provided and the power indicator light lights up, it shows that the unit has been
connected to the power supply. Concurrently, water tank decoration indicator light will also
light up. Heating indicator light turn on to indicate that the steam chamber being heated up.
Low steam setting indicator light turn on to indicate steam is set at low setting. During use, it
is normal that heating indicator light will cycle from on to off. this shows that steam chamber
automatically keeps temperature constant.
3. Set temperature setting button to steam ironing position according to fabric setting chart men-
tioned above. Heating indicator light at iron unit blinks slowly to indicate the unit being heated
up. When the heating indicator light change to light up steadily ,the desired temperature has
been reached. It is ready for steam ironing. During use, temperature indicator light sometimes
blinks, and sometimes lights up steadily, it does not indicate a defects or hazard, it is just
because the appliance are temperature constant.
4. Before every first time use, it is proposed to clean iron unit as following methods: take the iron
up from the base unit, press steam button underneath the handle to allow steam oN for 20
seconds, and then off for 30 seconds, this cycle should be repeated for 2 times. When tempe-
rature indicator light stops blinking, it is ready for use.
5. During steam ironing, please adjust steam rate according to your requirement as indicated in
the steam function setting.
6. After use, Set the temperature setting button to "Ready indicator light" position, and place
the iron back on the iron rest plate. Switch off the unit by pressing the power switch and then
unplug the appliance from the outlet.
7. Slide out the water tank and pour out the remaining water.
Note
• for every first time use, it is normal that's a slightly vibration sound may be occur-
red from electrical pump inside the base unit for a few seconds when steam
ironing started. It is because there is air inside the filter, it will stop till the air
inside the filter has been pumped out.
• During use, if steam stop escaping suddenly along with 5 BEEP sound alarm, or
water tank indicator light and water filling indicator light on control panel blink.
this indicates that it is time to fill water in water tank.
• for continous use of steam ironing, sometimes pump working indicator light will
turn off for several seconds,steam also will stop for several seconds. this is nor-
mal. It is because anti-drip function has been activated to protect leakage from
10 USER'S MANUAL I.WIP 1200 __________________________________________________________