Product Description; Use And Operation; Normal Operation; Specific Operation - SOMFY ROLLIXO io Manuel D'utilisation

Rollixo io

3 - ProDuCt DesCriPtion

The ROLLIXO receiver, linked to a Somfy RDO CSI motor and a Somfy safety
edge solution, is designed to drive a vertically opening roller garage door.

4 - use anD oPeration

4.1 normal operation

> operation with a Keygo io remote control
Press the programmed button to operate the door.
STOP
> obstacle detection operation
During closing, the detection of an obstacle causes the door to stop and re-
open partially.
The receiver warning light flashes rapidly to indicate that the door has
encountered an obstacle.
To return to normal operating mode, a command must be sent.
> integrated lighting operation
The lighting comes on each time the motor is switched on. It goes out
automatically 2 minutes after the door has stopped moving.

4.2 Specific operation

Depending on the additional accessories installed and the operating options
programmed by your installer, the system may have the following specific
functions:
> operation with a Keytis io remote control
• opening
• Closing
3
STOP
STOP
• stop
• movement interrupted
• movement not performed
> operation with a 3-button remote control
> operation with orange flashing light
The orange light flashes each time the motorisation is switched on, with or
without a 2-second warning depending on the configured parameter setting. It
stops flashing when the door stops.
> operation with cells
An obstacle placed between the cells will prevent the door from closing.
If an obstacle is detected while the door is closing, it stops, then re-opens fully.
The receiver warning light flashes rapidly until the obstacle is removed.
> operation with the alarm
The alarm is triggered for 2 minutes if the door is raised manually. No movement
of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it. The alarm can only be stopped with a memorised remote
control.
> operation in automatic closing mode
Automatic closure of the door occurs after a time delay programmed during
installation.
A new command during this time delay cancels automatic closing and the door
remains open.
The following command results in the closure of the door.
STOP
STOP
STOP
Copyright © 2014 Somfy SAS. All rights reserved.