Accessories; Service And Maintenance; Environment; General Information - Festool AGC 18 Notice D'utilisation D'origine

– Let the battery pack cool down.
Power tool overheated
– The power tool must cool down before it
can be started again.
Power tool fault
– Contact a Festool service workshop or spe­
cialist dealer.
Power tool jammed
– Eliminate the cause of the jam.
If the power tool switches off when it be­
comes jammed, no warning signal sounds.

11 Accessories

Always use original Festool accessories, as
described in the section on intended use. Us­
ing low-quality tools or accessories from other
manufacturers may increase the risk of injury
and seriously unbalance the machine, decreas­
ing the quality of the working results and accel­
erating machine wear.
The PO numbers of the accessories and tools
can be found in the Festool catalogue or online
at "www.festool.co.uk".

12 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work that re­
quires the power tool to be opened up
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
When machining mineral materials (e.g. gyp­
sum, etc.), dust deposits may build up in the
power tool housing and on the on/off switch and
harden when exposed to humidity. This may im­
pair the switching mechanism and cause the
power tool to overheat.
When machining metal, conductive dust depos­
its may build up inside the power tool. This can
cause a short-circuit.
► After each machining process, blow out the
inside of the power tool through the vents
and the on/off switch using dry, oil-free
compressed air.
Clean the sanding tools after use.
Keep the contacts on the power tool, charger
and battery pack clean.

13 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

14 General information

14.1 Bluetooth
®
The Bluetooth word mark and the logos are
®
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
English
25