Publicité
Les langues disponibles
Les langues disponibles
►Always use the guard provided with the tool.
The guard must be securely attached to the
power tool and positioned for maximum
safety, so the least amount of wheel is
exposed towards the operator. Position
yourself and bystanders away from the plane
of the rotating wheel.
The guard helps to protect operator from broken
wheel fragments and accidental contact with wheel.
►Use only diamond cut-off wheels for your power
tool.
Just because an accessory can be attached to your
power tool, it does not assure safe operation. ►The
rated speed of the accessory must be at least
equal to the maximum speed marked on the
power tool.
Accessories running faster than their rated speed
can break and fly apart.
►Wheels may only be used for recommended
applications. For example: do not grind with the
side of cut-off wheel.
Abrasive cut-off wheels are intended for peripheral
grinding, side forces applied to these wheels may
cause them to shatter.
►Always use undamaged wheel flanges that are of
correct diameter for your selected wheel.
Proper wheel flanges support the wheel, thus
reducing the possibility of wheel breakage.
►The outside diameter and the thickness of your
accessory must lie within the capacity rating of
your power tool.
Incorrectly sized accessories cannot be adequately
guarded or controlled.
►The arbour size of wheels and flanges must
properly fit the spindle of the power tool.
Wheels and flanges with arbour holes that do not
match the mounting hardware of the power tool will
run out of balance, vibrate excessively and may
cause loss of control.
►Do not use damaged wheels. Before each use,
inspect the wheels for chips and cracks. If the
power tool or wheel is dropped, inspect for
damage or install an undamaged wheel. After
10/2012 Estrichfugenschneider EF 135, #68679
inspecting and installing the wheel, position
yourself and bystanders away from the plane of
the rotating wheel and run the power tool at
maximum no load speed for one minute.
Damaged wheels will normally break apart during
this test time.
►Wear personal protective equipment. Depending
on the application, use a face shield, safety
goggles or safety glasses. As appropriate, wear
a dust mask, hearing protection, gloves and a
workshop apron capable of stopping small
abrasive or workpiece fragments.
The eye protection must be capable of stopping
flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating
particles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing
loss.
►Keep bystanders a safe distance away from the
work area. Anyone entering the work area must
wear personal protective equipment.
Fragments of workpieces or of a broken accessory
may fly away and cause injury beyond immediate
area of operation.
►Hold the power tool only by the insulated
gripping surfaces when performing an operation
where the cutting tool may come into contact
with hidden wiring or its own cord.
Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and shock
the operator.
►Position the cord clear of the spinning
accessory.
If you lose control of the power tool, the cord may be
cut or snagged and your hand or arm may be pulled
into the spinning accessory.
►Never lay the power tool down until the acces
sory has come to a complete stop.
The spinning accessory may grab the surface and
pull the power tool out of your control. ►Do not
run the power tool while carrying it at your
side.
21
Publicité
