Etherma LAVA FRAME Instructions D'installation Et D'utilisation page 13

I N S T A L L A T I O N I N S T R U C T I O N S F O R F L U S H W A L L A N D C E I L I N G I N S T A L L A T I O N
Please inspect the power supply cord to the heater and the
surface before installation. These must not show any signs of
damage. For wall mounting, pay attention to the direction ar-
rows on the back of the LAVA
1. Unpack the device and accessories and check that they are
complete and undamaged. Please place the infrared heating
device only on clean, level surfaces so that no dirt can get into
the panel surface and to avoid damage to the surface.
2. Detach the panel from the mounting frame by pressing on
the front of the panel and releasing the springs. Then, fold the
panel up by the springs and release it from the latching device.
3. Please note that in order to secure the frame with screws,
mounting aids (e.g. an aluminium profile or squared lumber
firmly connected to the ceiling) must be mounted on all four
sides of the cut-out.
®
before installation.
4. Insert the mounting frame into the cut-out. Make sure that
the frame is flush with the ceiling or wall. Check all of the
sides, for example with a spirit level.
5. Next, fix the frame to the mounting aid with countersunk
screws in the holes provided for this purpose.
Check again that the frame has not warped during installation
and is installed at a right angle.
6. Now, suspend the panel from the latching device.
13