FALMEC Sintesi Mode D'emploi page 32

Before connecting the cooker to the mains power network, check that:
• the mains voltage corresponds with the voltage indicated on the
data plate located inside the cooker;
• the electrical system is compliant and can withstand the load (see
the technical specifications located inside the cooker);
• the power supply plug and cable do not come into contact with
temperatures exceeding 70 °C;
• the power supply system is effectively and properly connected to
earth in compliance with regulations in force.
• the socket used to connect the cooker is within reach.
In case of:
• devices fitted with cables without a plug: the type of plug to use is
a ''standardised'' one. The wires must be connected as follows: yel-
low-green for earthing, blue for neutral and brown for the phase. The
plug must be connected to an adequate safety socket.
• fixed equipment not provided with a power supply cable and plug,
or any other device that ensures disconnection from the electrical
mains, with an opening gap of the contacts that enables total discon-
nection in overvoltage category III conditions.
Said disconnection devices must be provided in the mains power
supply in compliance with installation regulations.
The yellow/green earth cable must not be cut off by the switch.
The Manufacturer declines all responsibility for failure to comply with
the safety regulations.
Connection of the cooker (Panoramico 90):
network Connection
220V - 240V~
1P+N / 2P
50/60Hz
380V - 415V~
2P+N
50/60Hz
380V - 415V~
3P+N
50/60Hz
* calculated with the contemporary factor in compliance with EN 60
335-2-6.
PANORAMICO
90
Control description
Cooker top ON/OFF. In case no other control is
enabled, the cooker switches off automatically after
a few seconds
Selection of the front cooking area. If pressed
together with
Selection of the back cooking area. If pressed
together with
Control block: pressed for more than 2 seconds it
inhibits all controls. To release controls, repeat the
operation.
Increase of the power level for cooking and booster
selection, or increase of cooking time of the TIMER
function.
Decrease of the power level for cooking and booster
selection, or decrease of cooking time of the TIMER
function.
Cable Power Switch
section cable gauge
H 05 VV - F
3 x 2.5 mm² 25 A *
H 05 RR - F
H 05 VV - F
4 x 1.5 mm² 16 A *
H 05 RR - F
H 05 VV - F
5 x 1.5 mm² 16 A *
H 05 RR - F
it enables the BRIDGE function.
it enables the BRIDGE function.
1 2
POWER:
Feature
Total power
Position 1
Rated power
Booster power
Position 2
Rated power
Booster power (1/2)
Position 3
Rated power
Booster power (1/2)
Position 4
Rated power
Booster power
Display description
display
Cooking area in stand-by
Levels of power from the lowest to the highest one,
which can be selected pressing the keys + and -.
Power boost : maximum cooking power.
Indication of the residual heat
level of power between 0 and 1, suitable to
keep dishes warm
bridge function enabled.
(minimum saucepan diameter: Ø230 mm)
Saucepan not on the cooker or not suitable for
material and size.
(minimum saucepan diameter: Ø 120 mm)
(on Control block function enabled.
(su
+
central
display
display)
centrale)
32
3 4
90
2800-7400W
1600W
1850W
2100W
3000W
2100W
3000W
1600W
1850W