Safety Information - Renkforce SAP-702 Notice D'emploi

Safety Information

In case of damage caused by non-compliance with these safety instructions the warranty /
guarantee will become void. We do not assume any responsibility for consequential damage!
Nor do we assume any liability for damage to property or personal injury caused by improper
use or failure to observe the safety notices. In such cases the guarantee/warranty will be void.
Dear Customer, The following safety notices are intended not only for the protection of the device but also
for the protection of your health. Please read the following items carefully:
• The unauthorized conversion and/or modification of the product is inadmissible for safety and
approval reasons (CE).
• All persons operating, installing, setting up, commissioning or servicing this device must be trained
and qualified appropriately and observe these operating instructions.
• This device is a safety class II product. Only connect the miniature amplifier to a regular mains socket
(230 V~/ 50 Hz).
• The device must be set up correctly. Please also follow these operating instructions.
• When setting up the product, make sure that the mains cable is not pinched or damaged by sharp
edges.
• If the miniature amplifier or its connecting cable are damaged, do not touch them. First, power down
the respective mains socket (e.g. via the circuit breaker) and then pull the mains plug out of the mains
socket carefully. Do not use the product anymore afterwards but bring it to a specialised workshop.
• This product is not a toy and should be kept out of the reach of children! Children cannot judge the
dangers involved when handling electrical devices.
• Do not place any containers with liquid, e.g. buckets, vases or plants in the immediate proximity of
the product. Liquids could get into the device and impair its electrical safety. There also is a high risk
of fire or of a life-threatening electric shock. If this is the case, first power the respective socket down
(e.g. switch off circuit breaker) and then pull the mains cable from the socket. Disconnect all cables
from the device. After that, the product must no longer be used; take it to a specialist workshop.
21