Dehumidification - Bosch PAM17000 Mode D'emploi

Do not form sharp bends when positioning
the tube, otherwise the correct expulsion
of hot air may be impeded. This may cause
a reduction in the cooling power and
performance of the appliance.
In order to achieve maximum cooling
efficiency and minimum noise levels, the
expulsion tube should be fitted above the
total height of the appliance, Fig. 19.
Fig. 19

Dehumidification

In position , the appliance reduces the
humidity in the atmosphere.
Set the thermostat to its minimum
temperature setting, Fig. 20.
20°
Place a bowl at the drainage pipe outlet and
remove the plug to collect the condensed
water, Fig. 21
Instructions for Use
°C
Fig. 20
30°
Remove the diffusion duct and set the air
expulsion tube to the position shown in
figure 22.
The expulsion tube may also be totally
dismantled if desired.
Lift the air director on the top of the
appliance. This air director is not installed
on the appliance on PAM18100 models.
See figures 25 and 26 in "Heating".
Select the dehumidification function
the control knob, Fig. 23.
Warning!
The amount of dehumidified water may
reach a maximum of 36 litres in 24 hours,
depending on ambient conditions. See
"Technical Information".
28
Fig. 21
Fig. 22
on
0
Fig. 23