Only Dehumidification - Bosch B1 RKM 16002 Mode D'emploi

Only
dehumidification
Mode
24
38
The water produced during this process by
condensation is led outside and released from
the condenser by evaporation.
If the red warning light comes on
Condensed water has unduly accumulated in the
tank on the indoor unit.
Condensed water is emptied using the flexible
drainage pipe, which is coupled onto the water
drainage nozzle on the bottom of the appliance,
(see description of your appliance, page 28).
Fig. 23.
Make sure that the flexible duct which joins the
two units has not been squashed or been
trapped in any way. The difference in height
between the two units should not exceed 1.5 m.
Fig. 7.
Set the function at this setting, the appliance will
only reduce the humidity present in the
atmosphere, without affecting the temperature. The
appliance is capable of extracting up to 60 litres of
water a day from the air depending on atmospheric
conditions.
Release the water from the outdoor unit by
removing the plug from the lower tray.
Move the outdoor unit to the room that you wish
Speed
to dehumidify
Connect the flexible water drainage pipe to the
drainage nozzle on the outdoor unit and collect
the water produced by condensation in a suitable
receptacle, Fig. 25.
Turn the appliance on using the "On/Off" button.
Select the "Dehumidification"
button. Fig. 24.
The speed of the ventilator can be set to five
different levels, from 1 (minimum) to 5
(maximum), using the
Dehumidification power depends on the
ventilator speed selected.
:
function with the
and the buttons.