Dometic M55L Mode D'emploi page 17

PerfectView M55L, M75L
Connecting the monitor as a reversing video system (fig. d, page 7)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green cable (7) to
the positive cable of the reversing light.
I
NOTE
If voltage is present in the green cable (7), the reversing camera will be activated
automatically. The reversing camera has priority.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the following
control cable to a positive cable of the indicator:
– white cable (8)
I
NOTE
If voltage is present in this control cable, the video input CAM2 will be activated.
This control cable is used as a signal cable for the activation of a side camera when an indicator is
flashing, for example.
➤ If necessary, connect the CAM1 socket (9) of the connection cable to the plug of the video
source 1 (e.g. side camera).
➤ If necessary, connect the CAM2 socket (10) of the connection cable to the plug of video
source 2 (e.g. camera).
I
NOTE
Observe the power consumption of the video system. The cameras are equipped with
heaters. A maximum current of 1.5 A can flow (three cameras in heating mode). Use a
disconnector switch for direct connection to the battery. This allows you to disconnect
the video system from the battery easily if you are no longer using the vehicle.
Connection for a reversing camera
➤ If necessary, connect socket CAM3 (11) of the connection cable to the plug of the additional
reversing camera.
EN
Installing the LCD monitor
17