UWELL NUNCHAKU Mode D'emploi page 65

UWELL Nunchaku – Using the Device
Settings in Variable Wattage Mode (Power)
Press the Up or Down button in Power mode to set the watt value Hold down the corresponding button
to change the value more quickly. The watt settings can be configured from 5 to 80 watts. If you drop
below 5 watts or exceed 80 watts, you will automatically switch to the highest or lowest watt value.
Note: If the vaping voltage is too low, the output power will not be capable of reaching the desired
pre-settings, since the output power automatically adapts.
Settings in TC Mode (NI-, SS-Temp)
Push the up or down buttons in temperature mode to set the temperature from 100 °C to 315 °C
or from 200 °F to 600 °F. In order to change the unit of temperature from Fahrenheit (F) to Celsius
(C), increase the temperature value to the maximum or minimum level. If you change the set value
even further above or below this range, the display will automatically switch to the other unit.
63