Assembly Instructions; Operating Instructions; Selecting The Operating Mode; Starting And Stopping The Machine - VITO GARDEN VIAS3000A Mode D'emploi

EN
3. ASSEMBLY
INSTRUCTIONS
3.1 - ASSEMBLY OF SUCTION/
BLOW PIPES
1. Fit the middle suction/blow pipe (4)
into the main body (5);
2. Insert and tighten the screws;
3. Fit the final suction/blow pipe (2)
into the middle suction/blow pipe;
4. Insert and tighten the screw;
3.2 - COLLECTION BAG
ASSEMBLY
1. Attach the tabs of the collecting bag
fitting (13) into the main body (5);
2. Ensure that the bag insert is firmly
attached to the main body;
3. Insert the accessory of the collection
bag (16) into the harness for the
collection bag (3);
3.3 - FASTENING THE
CARRYING STRAP
1. Place the hanger of the carrying
strap (17) into the hook for the carrying
handle (7);
2. Ensure that the hook is firmly
attached;
3. Adjust the length according to the
desired working position;
4. OPERATING
INSTRUCTIONS
The blower/vacuum can be used
to blow waste from patios, paths,
sidewalks, lawns, shrubs,
vacuuming leaves, small branches and
wood chips.
When using the blower&vacuum in
suction mode, the debris are drawn
through the suction tube and passed
through the fan where they are partially
crushed before being stored in the
collection bag. The crushed organic
debris is ideal for use as dead mulch
around plants.
When operating the blower, some
procedures must be followed in order
to avoid accidents and damages and
increase the machine's efficiency:
� Avoid vacuuming wet materials.
Otherwise, the fan can lock and
performance of the vacuum / blower
may decrease;
� Never vacuum or blow hard objects
such as rocks, bottles, cans or pieces
of metal. These types of objects can
damage the fan and cause injury to the
user;
� To avoid damaging the motor due
to excessive speed, do not block the
opening of the final suction/blow pipe;
� Always hold the blower/vaccum with
both hands;
� Do not use the blower/vacuum in
areas where there are noxious dust;
� Use rakes and brooms to loosen
debris before blowing;
4.1 - SELECTING THE
OPERATING MODE
The machine can be used as a vacuum
cleaner or blower.
Vacuum mode
1. Set the operating mode selector (12)
in the horizontal position;
Blower mode
2. Set the operating mode selector (12)
and in the vertical position;
Before changing the operation
mode to suction, ensure that
the collection bag is firmly seated.
4.2 - STARTING AND STOPPING
THE MACHINE
1. Press the "ON/OFF" switch (10) to
start the machine;
2. To stop the machine, release the
"ON/OFF" switch;
4.3 - USING THE BLOWER &
VACUUM
1. Check that the collection bag (14) is
in place;
2. Set the operating mode selector (12)
to horizontal or vertical depending on
the type of work you want to perform;
3. Hold the machine with both hands;
4. Move the machine properly to the
job to be performed.;
5. Hold the end of the final suction/
blow pipe (2) 5-10 cm from the floor
during aspiration;
4.4 - CLEANING THE
COLLECTION BAG
Always make sure that the machine
and cable are disconnected before
emptying the collection bag.
A full collection bag reduces suction
capacity. This way, you must remove
and empty the collection bag when
it is full or interferes with the suction
capacity.
1. Remove the accessory (16) and the
fitting (13) from the collection bag;
2. Unzip the collection bag's zipper
(15);
3. Empty the bag. Shake it to remove
the dust and other debris;
25