Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Comment: if the filter is obstructed or if the grid is covered involuntary, a
special sensor switches off the device. The normal operating of the device
will start again at the next start-up, if the filter or the grid is not obstruc-
ted, and only after the blower has cooled down.
-
If the ambient temperature reaches the maximal Boost tem-
perature during the count:
The blower switches off but
the Boost mode is always
active : the count is always
displayed, the Boost symbol
and the heating indicator
flash on the display. When
the temperature drops un-
der the maximal authorised temperature, the blower will be restarted
until the count ends.
- Second press = Boost cancellation.
The cursor moves above the previous active mode and the setting tem-
perature appears.
POST-VENTING
When the blower and the heating cartridge switch off, the venting
continues to operate during few seconds to preserve and optimize the
product life time.
Seconds appear and begin to count
down, the keypad is inactive du-
ring the post-venting.
SUPER COMFORT
The blower could be used as an instant additional heating in case of
important difference between the ambient temperature and the setting
temperature desired.
The Super Comfort switches on if the difference between the ambient
temperature and the setting temperature is higher than 2°C.
The Super Comfort is enabled by default
page 13 then Super Comfort mode page
Example: the device is in Eco set 17,5°C, you decide for a transition in
Comfort mode : the difference between 21°C and 17,5°C is 3,5°C, so hi-
gher than 2°C.
The blower starts up automatically to help the temperature increase
and attain the 21°C requested.
The Boost symbol and the
heating indicator appears on the
display and the cursor above the
selected mode will flash.
scf
and the setting temperature Super Comfort appears alternately on
the display.
The Super Comfort stops if:
- The difference is less or equal to 0,5°C.
- The difference is always upper than 2°C after 1hr of Super Comfort.
Comment: the Super Comfort is valid in Comfort and Auto-Comfort
mode only.
GAUGE CONSUMPTION, ENERGY SAVINGS
France's Agency for Environment and Energy Management (ADEME) re-
commends a Comfort setting temperature lowerr or equal to 19°C.
In the device display, a selector indicates the energy comsumption level
by positioning it in front of the colour: red, orange or green. So, depen-
ding on the setting temperature, you can choose your level of energy
(see chapter advanced settings
13).
usage. As the temperature setting
increases, the consumption will be higher.
The gauge appears in Auto, Comfort, Eco and Frost protection modes
and whatever the temperature level.
Setting temperature
C - Red colour
High Temperature level:
it is advisable to signifi-
When the setting
cantly reduce the setting
temperature is higher
temperature.
than 22°C
19°C < Setting tempe-
B - Orange colour
rature ≤ 22°C
Average temperature
When the setting tem-
level: it is advisable
perature is higher than
to slightly reduce the
19°C and lower or equal
setting temperature.
Setting temperature
A - Green colour
When the setting
Ideal temperature.
temperature is lower or
equal to 19°C
SETTING THE COMFORT MODE
TEMPERATURE
You can access the Comfort temperature set up from the Auto and
Comfort Mode. It is preset to 19°C.
Using
and
you can adjust the temperature from 7°C to 30°C
by intervals of 0.5° C.
Note: you can limit the Comfort temperature,
tails.
CONSUMPTION INDICATION
ACCUMULATED IN KWH, ENERGY
SAVINGS
It is possible to see the estimation of energy consumption in kWh since
the last reset of the energy meter.
Display of the estimated power consumption
To see this estimation, from Auto,
Comfort, Eco or Frost protection mode,
then press
.
To exit the display mode of
consumption: press any button, the
device is automatically in the previous active mode.
Resetting the energy meter
To reset the energy meter, from Auto, Comfort, Eco or Frost protection
mode, then proceed as follows.
1- Press
.
EN
> 22°C
to 22°C
≤ 19°C
see page 14 for more de-
1 2 3 4 5 6 7
M16MI328 A04_02/18 R
5
Publicité
Chapitres
Table des Matières
