Operation; Diagram; Power On /Standby Mode - RADSON PTC BLOWER 950W Notice D'utilisation

OPERATION

DIAGRAM

• Buttons overview
2
1
1
Selecting operating modes
Plus and minus buttons, used to set temperatures, time, date and
2
programmes
3
Save settings
4
Boost
• Indicators overview
1
2
2
3
4
1
Boost indicator light
2
Gauge consumption
3
Heating indicator
4
Days of the week (1=Monday ... 7= Sunday)
5
Setting temperature
6
Occupancy detection indicator
7
Open window detection indicator
8
Keypad locked
9
Radio transmission indicator
Operation modes:
10
Auto mode
Comfort mode
Eco mode
Frost protection mode
Time and date setting mode
Programming mode
Settings
Important: In Auto, Comfort, Eco and Standby mode, backlight turns
off automatically after 20 seconds if no buttons are pressed. It will be
necessary to reactivate it by pressing one of the keypad buttons before
making settings.
Before carrying out any setting procedures, ensure that the
keypad is indeed unlocked
2 3
10
5 6
(see page 6).

POWER ON /STANDBY MODE

Power on feature
When this feature is first used, press the button (switch) so that it swit-
ches to the I located below the blower to put the device in operation.
4
The device is in Auto mode.
Note: The heating indicator light will come on only if the measured
temperature is below the preset temperature.
If the ambient temperature is below the set temperature by 2°C, the
blower will switch ON (see page 6 Super comfort for further
Standby feature
9
Since the button (switch) is on I, press it to switch it to the other posi-
tion.
8
7
Note:
The settings that are adjusted during operation are automatically saved
and will be applied at the time of the next use.
E.g.: if the blower is operating and you want to switch the appliance to
standby, the next time the appliance is switched on, the boost feature
and the timer countdown will also be switched back on. Reversion to
the mode selected before the boost feature was switched on will apply
when the blower switches off.
Important:
Before carrying out any setting procedures, ensure that the
keypad is indeed unlocked
EN
details).
(see page 6).
M16MI328 A04_02/18 R
3