iKarus NG-6 Notice D'utilisation page 6

Operating Instructions 2.4 GHz 6-Channel Transmitter NG-6
Technical Specifications
System:
Transmitter Frequency: 2.4 GHz
Overview transmitter front
(Pic. 1)
Simulator Interface
Connector (on back
of transmitter)
Strap Mount
3-Step Switch
Channel 5
Control Stick for
Throttle (Mode 2)
or Forward Pitch/
Elevator (Mode 1)
and Tail/Rudder
Trim Lever
On/Off Switch
Battery
Compartment (on
back of transmitter)
* The imprints on the transmitter are referring to Mode 2: AIL (aileron, roll) = Channel 1, ELE (elevator, pitch forward) =
Channel 2, THR (throttle, pitch) = Channel 3, RUD (rudder, tail control) = Channel 4.
System Description
This remote control unit is a 6-channel hand held transmitter for controlling model airplanes and
helicopters. The four main channels can be reversed in their operating direction directly at the
transmitter. This simplifies the servos installation in your respective model.
The simulator connector on the back of the transmitter allows the connection of your transmitter to a
PC via an interface cable (with 3.5 mm stereo cinch connector). This way you are able to control R/C
flight simulator programs such as "Aerofly 5" or EasyFly3" with your transmitter.
6-channel transmitter
Servo
Mixer ATV Reverse
Switch*
Operating Voltage:
Signal Transmission:
Status LED
6
9.6-12V
FHSS
Antenna
Battery Voltage
2-Step Switch
Channel 6
Control Stick for
Throttle (Mode 1)
or Forward Pitch/
Elevator (Mode 2)
and Roll/Aileron
Trim Lever
Charge Jack
Programming
Knob