Calculated Industries SCALE MASTER CLASSIC 6020 Guide De L'utilisateur page 11

iii.Press [Scale] to advance through
the flashing digits until the display
returns to zero. The height is now
stored.
b. To Enter and Store a Height:
i. If you are entering a height (instead
of rolling), press [Subtract/Count]
and [M2x] simultaneously. The unit
of measure will begin flashing.
ii. If you do not want to change the
unit of measure, go to step iii. To
change the unit of measure, press
[M1+] until you reach the desired
unit.
iii.Press [Scale] to begin setting the
digits. The left-most digit will
begin flashing.
Press:
[M1+] to increment this digit,
[Subtract/Count] to decrement,
[Scale] to advance to next digit,
[Mode] to move back one digit.
iv. Continue pressing [Scale] until all
digits are set and the display returns
to zero. The height is now stored.
Note: Once you set your height, you do not need
to enter it again unless you want to change it.
4) Press [Rcl] [M2x]. This displays the
linear value stored in this register.
Press [M2x] a second time to calculate
and display the area. Press the [M2x]
key again to find volume. Press [M2x]
a fourth time to display the stored
height value.
11 – User's Guide