Whirlpool W10254423A Guide D'utilisation Et D'entretien page 7

CYCLE GUIDE — SPECIAL-PURPOSE CYCLES
Settings and options shown in bold are default settings for that cycle. For best fabric care, choose the cycle that best fits the
load being washed.
Not all cycles and options are available on all models.
For best performance, not all settings are available with each cycle, and some options cannot be used together.
Items to wash
Cycle:
using default
cycle settings:
Swimwear, items Rinse/Drain
that need rinsing only
Wet load of clothes Rinse/Drain
Sturdy garments and Allergen
household items
exposed to possible
allergens
Jeans and denims
(on some models)
No clothes in washer Clean Washer
* All temperature selections feature a Cold rinse, except Warm*, which features a warm wash and a warm rinse.
† Sanitize
Cycles certified by NSF International, an independent, third party testing and certification
organization are those with the sanitize temperature selection available. The certification
verified that these cycles reduce 99.9% of bacteria typically found on clothing, bedding,
and towels. There is no carryover of bacteria between loads after the cycle is complete. Only
cycles with sanitize wash temperature selected have been designed to meet the requirements
of NSF Protocol P172 for Sanitizing Effectiveness.
†† Allergen
Allergen cycle certified by NSF International, an independent, third party testing and certification
organization. The certification verified that this cycle reduced tested allergens by at least 95.0%
and maintained the water temperature necessary to kill dust mites. Only the allergen cycle has
been designed to meet the requirements of NSF Protocol P351 for Allergen Reduction Performance
effectiveness.
Wash
Temperature*:
Warm*
& Spin Warm
Cold
N/A
& Spin
Sanitize
†† †
Hot
Warm
Jeans
Cold
Cycle
Spin Soil
Available
Speed: Level:
Options:
Extra High N/A Extra Rinse
High FanFresh
Medium Delay Start
Low
No Spin
Extra High N/A FanFresh
High
Medium
Low
Extra High Heavy
Extra Rinse
High Normal Deep Clean
Medium Light
FanFresh
Delay Start
Medium
Heavy Extra Rinse
Low Normal
No Spin Light FanFresh
Delay Start
Cycle Details:
This cycle adds water, then uses
high-speed tumbling and an extra
high-speed spin. For some fabrics,
you may wish to set the spin speed
to a lower setting.
Use Drain & Spin to remove excess
water from the load by choosing
Rinse/Drain & Spin and turning off
Extra Rinse. Spin speed can be set
to a lower setting.
Uses more water to flush out
allergens such as exposed to
Presoak dander from normally-soiled items
Cycle combines low-speed
Presoak tumbling and medium-speed spins
to provide gentle care for jeans and
denims.
Use monthly with Affresh
the interior of the washer. Make
sure no clothes are in washer. The
Clean Washer light will flash every
30 loads to remind you to run the
Clean Washer cycle.
to clean
®
7