Out Of The Box; Pc Requirements; Software; Hardware - Honeywell TESTAIR 4 Guide D'installation

2. Out of the box

The TestAir 4 is delivered with the following items:

TestAir 4

Medium Pressure Manifold

High Pressure Manifold for 200 bar

High Pressure Manifold for 300 bar

CD-ROM with BA Test Software

Setup Guide

USB Cable

Power Cable

"Air-Klick" – RD40 adaptor

RD40 blank gasket

Support for F1 facepieces tests

Microphone

3. PC Requirements

3.1 Software

The TestAir 4 Software has the following OS
requirements:

Windows XP to Windows 7, 32 or 64 bit.
In order to install the software, the software installer
must log on as system administrator.

3.2 Hardware

Make sure that your computer system meets the
minimum requirements prior to attempting to
install or use TestAir 4 Software. Inadequate
system resources may prevent the software
from operating properly on your system. The
minimum specifications for the computer used
to run TestAir 4 Software vary according to the
operating system used.

Pentium 4 processor 2.0 GHz or higher

512 MB RAM

50 MB hard drive space

USB 2.0 Port

CD-ROM drive (for installation of software)
4. Software
For sofware installation and database setup, please
refer to the PDF file, "Setup Guide Posi3 USB"
paragraph 4, attached to the TestAir 4.

5. Hardware Setup

5.1 Connect the TestAir 4 to the PC

The TestAir 4 is connected to the PC via USB cable.
Once the software is installed and the TestAir 4 is
assembled, use the USB cable to attach the TestAir 4
to the PC.

5.2 Turn on the power

To turn the TestAir 4 on, simply plug the power cord of
the TestAir 4 into a grounded outlet and flip the rocker
switch located on the rear panel of the TestAir 4
chassis.
Note: HRSP recommends that the TestAir 4 be
plugged into a surge protector. Failure to use a
surge protector may lead to sporadic loss of
communication between the TestAir 4 and the PC.
Do not attach the pressure-reducing manifold, or
mount an SCBA facepiece on the test head prior
to turning the TestAir 4 on. Doing so prior to
completion of the electronic self test and startup
sequence may result in damage to the TestAir 4
and/or incorrect test data.
The USB Drivers must be installed prior to launching
the TestAir 4 software. The USB driver installation is
covered in section 4.1 above (see step 21) and is also
discussed in the TestAir 4 Installation Help File.

5.3 Install the microphone

The microphone is need to be installed prior to
launching the software.
1. Plug the microphone into the port located on the
TestAir 4's left front panel over the medium
pressure inlet.
Coiled Cable
Microphone and Carrier Arm Assembly
2. The software will automatically recognize the
microphone when the TestAir 4 is initialized.
The microphone is only used in the Complete
SCBA Test. For further instructions on using the
microphone, see the TestAir 4 Help File.
EN-4
Jack
Flexible arm
Microphone
Clip