Warnings And Cautions; Electrical Requirements - Honeywell TESTAIR 4 Guide D'installation

EN
THESE INSTRUCTIONS ARE FOR EXPERIENCED PERSONNEL, TRAINED AND FAMILIAR WITH WEARING
BREATHING APPARATUS
CE regulations are applied to complete apparatus matching the CE certified configurations by notified bodies
that have carried out CE type examinations.
Failure to comply with this procedure immediately invalidates the CE marking.
To find out all the approved configurations, refer to the configuration tables, available on request.
HONEYWELL RESPIRATORY SAFETY PRODUCTS is continuously endeavouring to improve all its products
and the equipment supplied is subject to change without notice. Consequently, the information, illustrations
and descriptions provided in this document may not be used as a reason to demand the replacement of
equipment.
Being in possession of these instructions does not automatically authorise the holder to use TestAir 4; only
appropriate training will enable safety procedures to be followed.
HONEYWELL RESPIRATORY SAFETY PRODUCTS accepts no liability if the recommendations contained in
this document are not followed.
The recommendations in boxes have the following meanings:
Failure to follow the instructions in boxes could seriously damage the
equipment used and put the user in danger.
Failure to follow the instructions in boxes could lead to incorrect use of
the equipment and result in damage to the equipment.

Warnings and Cautions

Do not open the TestAir 4's case while it is powered up. Contact with the TestAir 4's powered internal
circuitry may lead to death or serious injury.
SCBA Cylinders are under considerable pressure. Always follow the manufacturer's recommendations for
proper handling when working with compressed air cylinders. Failure to follow the manufacturer's
recommendations may lead to death or serious injury.

Electrical Requirements

The TestAir 4 is classified for use in the following electrical systems:
100-125 VAC, 50-60Hz using only 2A 250V Slow Blow Fuses
220-250 VAC, 50-60Hz using only 1A 250V Slow Blow Fuses
IMPORTANT
IMPORTANT
NOTE
EN-1