Walter Maxi-Grinder Série Manuel D'utilisation page 5

Safety instructions
11. Before further use of the tool, a handle, guard or any other part that may
be damaged, should be carefully examined to determine that it will operate
properly and perform its intended function. Check for alignment of moving
parts, binding or breakage of parts, mounting and any other condition that
may affect its operation. A guard, switch or other part that is damaged or
defective should be properly repaired or replaced by a WALTER Factory Service
Center or a WALTER Authorized Service Center.
Do not use the tool if the switch does not turn ON and OFF. Keep guards in
place and in good working order. Always use the side handle, when supplied,
for safety and better control.
12. Use the right power tool for the job at hand. Do not force a small tool to do the
job of a larger one. Use the tool for its intended purpose only. Never force it
beyond its rated capacity.
13. Use only tooling and accessories recommended for this power tool. Keep
cutting edges sharp and clean for safer and better performance. Always check
accessories and tooling before starting to work. Do not use if damaged or dull.
14. Keep hands away from cutting edges and all moving parts.
15. Do not touch accessories, tooling or work piece immediately after use,
they may be extremely hot and could cause serious burns.
16. Do not abuse the power cord. Never pull or carry a tool by its cord or yank
to disconnect it from the receptacle. Keep the cord away from heat, oil and
sharp edges. Inspect the cord periodically, if damaged, have it replaced by
a WALTER Factory Service Center or a WALTER Authorized Service Center.
17. Disconnect the power tool when it is not in use, before servicing, and when
changing accessories and tooling.
18. When not in use, store tools in a dry safe place, out of the reach of children
and other unqualified persons.
(continued)
Safety instructions (continued)
Maxi-Grinder User's Guide
3