LEGRAND 430 523 Manuel D'utilisation page 28

INSTALLATION WITH CEILING MOUNT BRACKET (430 595)
1 Remove the ceiling tile from the ceiling and cut a
hole whose diameter is 30~40mm on the ceiling
tile to pass the wire(s) and cable(s) through to
the upside of the ceiling. (In case of the wiring
and cabling through the mounting surface only)
Then prepare the ceiling mount bracket. Pull the
wire(s) for the system as below. (Anchor Bolt
3/8"x70)
3 Screw the dome cover to the main body and
remove the protection vinyl from the dome cover.
Important Notice
• Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
• To adjust the installation height from the mounting surface, the pipe and coupler should be needed
between the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling
mount bracket. Note that they are not supplied by the manufacturer.
+
+
2 Pull the wire(s) and cable(s) for the system as
below. Wire the cable(s) to the ports. Insert the
mounting hooks into the holes on the surface of
+
the main body and turn the main body. Assemble
the main both with the camera mount adaptor
with the 3 screws. (Machine M5x15)
28