Dip Switch Setup - LEGRAND 430 523 Manuel D'utilisation

DIP SWITCH SETUP

Before in
stalling the camera, set up the DIP switch to configure the camera ID and the communication protocol.
• Camera ID Setup
• DID numbers of cameras are set up with binary numbers. See the examples shown below.
Pin 1
Binary 1
Value
ex: ID = 5 on
ex: ID = 10 off
• The camera ID range is "1~255".
• The factory default of the camera ID is "1".
• Match the camera ID with the Cam ID setting of your DVR or Controller to control the camera.
• If you are connecting a single camera to a controller, terminate the camera. When connecting more than one
camera to a single controller, terminate the last camera on the communication line. The last camera means
the camera farthest in cable length from the controller.
• Note that the total length of the communication cable between a controller and the camera(s) on the same
communication line must be less than 1.2Km.
2 3 4
2 4 8
off on off
on off on
Camera ID must not be "0"!
25
5 6 7
16 32 64
off off off
off off off
8
128
off
off