Basic Settings And Calibration; Adjustment Of The Basic Settings - Nedo ET-5 Mode D'emploi

7

Basic Settings and Calibration

7.1

Adjustment of the basic settings

The unit MUST NOT be switched on to enter the setting menu.
Activate the setting menu:
Press and hold both the
at the same time and then press the
Release the
ON/OFF
be seen in the display. Then release the
buttons, after hearing four beeps. The
0SET
instrument is now in "setting mode", in which the
settings can be made.
Switching On/Off the acoustic indicator at 90°:
Press the button to switch between:
0SET
Indicator Off 
Indicator On 
Setting/changing the angle measurement
system:
Press the button to reach the "UNIT"
HOLD
parameter. In this mode you can choose between
degrees and gon units:
- Degrees [ ° ] - (0-360)
- Gon [ G ] - (0-400)
- MIL [ ] - (0-6400) - UNIT C
Press the button.
0SET
Setting/changing the type of reference:
Continue to press the
VErTICAL mode.
Here you can press the
between:
ZEN = = 0 and
ZEN = = 90
Setting/changing the time for automatic
switching off:
Continue to press the
AUTO OFF mode.
Switch automatic switching off after 30 min On -
[ 30 OFF ] or Off [ NO OFF ] with the ......... button.
Setting/changing the resolution of the angle
measurement system:
Continue to press the
mode appears. Choose between
- dSP 1  smallest display unit 1"
- dSP 5  smallest display unit 5"
Theodolite ET-5 Operating Instructions
and the
HOLD
button when all segments can
NO bEEP display
90 bEEP display
- UNIT A
- UNIT B or
button until you reach
HOLD
button to choose
0SET
 Zenith at 0°
 Zenith at 90°
button until you reach
HOLD
button until dSP
HOLD
0SET
buttons
0SET
button.
ON/OFF
+
HOLD
0SET
EN
+
24