Ondal Acrobat 2004 Mode D'emploi page 12

Welcome
Changes or modifications
Trademarks
Customer Service
Published by
Visit us on the Internet
Thank you very much
for purchasing the Acrobat 2004 wall arm. Please read through these Operating
Instructions carefully before using the appliance. This will allow you to take advantage
of all the features of this new appliance and protect yourself and others from possible
injury.
• The appliance is designed according to state-of-the-art technology and is safe to
operate. Hazards may nevertheless still occur with this appliance. In particular if it is
used by staff without sufficient training or if not used properly and in accordance
with its intended purpose.
• Please instruct staff about operation, cleaning and care of the appliance in accordance
with these Operating Instructions.
• Unauthorised changes or modifications to the appliance are not permitted for safety
reasons. Unauthorised changes, modifications or the use of parts not supplied by the
manufacturer or the manufacturer's agents will invalidate the manufacturer's
guarantee for this appliance.
The manufacturer is hereby exempt from any liability whatsoever for damage or
injury resulting from unauthorised changes or modifications or as a result of not
using OEM spare parts.
ONLY USE OEM SPARE PARTS!
• If you encounter special problems which are not covered in sufficient detail by these
Operating Instructions, please contact Customer Service for your own safety.
• Acrobat ® is a registered trademark.
• All other trademarks mentioned in these Operating Instructions are the sole property
of the relevant manufacturers.
Keep these Operating Instructions in a safe place near the appliance so you can look
up safety instructions and important information in the future. These Operating
Instructions are part of the appliance. Please do not pass on this appliance without the
Operating Instructions.
How to contact us
Customer Service is available for you
• if you have queries about the appliance or its installation
• when you want to order spare parts
• for servicing or guarantee claims.
You will find the address of your nearest Customer Service Centre in the back pages
of these Operating Instructions.
Published by
ONDAL Industrietechnik GmbH • Wellastrasse 2-4 • 36085 Hünfeld • Germany
Telephone: ++49 / (0)6652 / 81-0
© ONDAL Industrietechnik GmbH
Edition 04/2007, version 2
Subject to change without notice
www.ondal.de
14
GB