Water Connection; Electrical Connection - ELEKTRO HELIOS DI8526 Notice D'utilisation

Water connection

Water inlet hose
Connected the appliance to a hot (max. 60°) or cold
water supply.
If the hot water comes from alternative sources of en-
ergy that are more environmentally friendly (e.g. solar
or photovoltaic panels and aeolian), use a hot water
supply to decrease energy consumption.
Connect the inlet hose to a water tap with an external
thread of 3/4".
Caution! Do not use connection hoses from an
old appliance.
The water pressure must be in the limits (refer to the
chapter 'Technical data'). Make sure that the local wa-
ter authority gives you the average mains pressure in
your area.
Make sure that there are no kinks in the water inlet
hose and that the water inlet hose is not squashed or
entangled.
Turn the inlet hose to the left or the right to suit the
installation. Fit the locknut correctly to prevent water
leaks.
Caution! Do not connect the appliance to new
pipes or pipes that are not used for a long time.
Let the water run for some minutes, then connect the
inlet hose.

Electrical connection

Warning! The manufacturer is not responsible
if you do not follow these safety precautions.
Drain hose
1
Connect the water drain
hose to the sink spigot.
3
The internal diameter must not be smaller than the di-
ameter of the hose.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane (A). If
you do not remove the membrane, remaining food
can cause a blockage in the drain hose spigot.
Caution! Make sure that the water couplings
are tight to prevent water leakage.
This appliance needs to be earthed according to
safety precautions.
max 85 cm
min 40 cm
2
4
15