Care And Cleaning; What To Do If - ELEKTRO HELIOS DI8526 Notice D'utilisation

Care and cleaning

Warning! Switch the appliance off before you
clean the filters.
Cleaning the filters
Important! Do not use the appliance without the
filters. Make sure that the installation of the filters is
correct. Incorrect installation will cause unsatisfactory
washing results and damage to the appliance.
1
3
To remove filters B and
C, turn the handle ap-
proximately 1/4 anti-
clockwise.

What to do if...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the prob-
lem yourself. If you cannot find a solution to the prob-
lem yourself, contact the Service Force Centre.
2
Fully clean the filters A,
B and C below running
water.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, re-
move remaining parts of soil with a cocktail stick.
External cleaning
Clean the external surfaces of the appliance and con-
trol panel with a damp soft cloth. Only use neutral de-
tergents. Do not use abrasive products, scouring
pads or solvents (acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is
not responsible for damage because of frost.
If not possible, empty the appliance and close the
door. Disconnect the water inlet hose and remove wa-
ter from the water inlet hose.
Caution! Switch off the appliance before you
do the below suggested corrective actions.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
11