Installation - ELEKTRO HELIOS DI8526 Notice D'utilisation

packaging materials in the applicable container at the
community waste disposal facilities.
Warning! To discard the appliance, follow the
procedure:
• Pull the mains plug out of the socket.

Installation

Warning! Make sure that mains plug is
disconnected from the mains socket during
installation.
Put the appliance adjacent to a water tap and a water
drain.
Install the appliance under a kitchen counter or work
surface.
Make sure that the dimensions of the recess agree
with the given dimensions.
No further openings for the venting of the dishwasher
are necessary, but only to let the water fill, the drain
hose and the power supply cable pass through.
Make sure that there are no kinks in the water hoses
and that the water hoses are not squashed.
Adjusting the height of the appliance
Do these steps to adjust the height of the appliance:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot. Turn the screw in the middle
of the front kick plate to the left or to the right.
Make sure that the appliance is level to close
and seal the door correctly. If the level of the ap-
pliance is correct, the door does not catch on the
sides of the cabinet. If the door does not close correct-
ly, loosen or tighten the adjustable feet until the appli-
ance is level.
Adjusting the height of the plinth
14
• Cut off the mains cable and mains plug and dis-
card them.
• Discard the door catch. This prevents the children
to close themselves inside the appliance and en-
danger their lives.
If there is a space at the bottom of the machine, you
can lower the plinth to cover it.
Adhesive steam protection foil
Fit the steam protection on the front part of the work-
top along the entire width.
Fixing to the adjacent units
Warning! Use the supplied brackets to attach
the appliance under the worktop or to the
adjacent units, to prevent injury or damage.
1. Fit the supplied angular brackets in the slots on
the top of the appliance.
2. Use the supplied screws to secure the appliance
in position (upwards or sideways). Make sure the
screws are tightened.