Publicité
Les langues disponibles
Les langues disponibles
CHARGING A LEAD-ACID BATTERY
• First ensure that it is a lead acid battery with a voltage of 6 V or 12 V.
Rechargeable batteries with other voltages cannot be charged!
• Disconnect all consumers from the rechargeable battery.
• If the rechargeable battery is built into a vehicle, switch off the ignition and all consumers.
Please strictly observe any and all information and safety instructions of the vehicle on how the rechargeable
i
vehicle battery needs to be charged. Modern vehicles are equipped with sensitive electronic components and
control units which will be damaged when handled improperly!
• First, connect the charger to power supply (220 – 240 V AC at 50/60 Hz).
• Connect the charger to the rechargeable battery observing correct polarity.
Reverse polarity on the connected rechargeable battery or a defective battery is indicated by LED 1.
• Then, you may select one of the two modes by using the MODE button.
Only in the first 10 seconds after connecting the rechargeable battery, it is possible to select the desired
i
charge mode. If you, for example, selected the wrong mode, you must disconnect the rechargeable battery
once again from the charger and reconnect it.
• After charging, disconnect the charger from the power supply.
• Then remove the terminal from the minus pole of the rechargeable battery and then from the plus pole.
CHARGING CURVES
Charging characteristic – 12 V mode
8
Publicité
