Function Selection; Panel Description - Eagletone Scan 250 Manuel De L'utilisateur

EAGLETONE 250 SCAN
INSTALLATION
• This light can be installed anywhere, provided a minimum
radius of 1 m is allowed between it and any surrounding
objects or people. The light must be safely and securely
fixed in place and correctly earthed.
• Make sure the local voltage and frequency are suitable for
this unit.
• The EAGLETONE 250 SCAN is turned on as soon as it is
correctly connected. Once on, the mechanism will move
into its initial position. The lamp will shut off automatically,
and the mini-step motor will turn to its limit point. The
internal calibrating system will memorize the position of
the motor.
• DMX 512 CONNECTION. The unit can be controlled via the
DMX 512 standard signal, using DMX cables (of 100/120
Ω impedance) equipped with 3-pin XLR input and output
connectors (caution: a microphone cable does not have the
same impedance nor the same bandwidth, it will therefore
generate errors).
• The signal cable should be less than 100 m, in order to
protect the signal. If the signal cable is too long, it will pick
up unwanted interferences generated by other pieces of
equipment. Make sure to end the DMX line furthest from
the controller with a 120 Ω termination resistor (connected
to pins 2 and 3 of the XLR connector) in order to absorb
signal reflections.
Note: When you are using a controller, each light has its own
digital address number, utilizing a 4 band signal. Therefore,
the first light's address number should be set to 1, the second
light should have its digital starting number set to 5, the third
light's should be set to 9, and so on. (This setting method
should be adapted to the type of controller being used and
is given as a general indication. If you are using a 192 DMX
controller, then calculate the values in sets of 6.)

PANEL DESCRIPTION

MODE FUNC UP
Mode: Selects the running mode.
Func: Selects the light function
UP/DOWN: Changes the parameter of the light
2
DOWN

FUNCTION SELECTION

Once the light is on, press the FUNC key, then use the UP and
DOWN keys to select from among the following functions:
• P0/P1: Pan Reverse,
• T0/T1: Tilt Reverse and
• D1/: Will turn off the Display Board.
OPERATING INSTRUCTIONS
Running mode
When the light is on, press down the MODE key, then choose
from among the following modes.
DMX mode
A.001: Use the UP/DOWN keys to select the desired channel
from A001 to A512 and therefore automatically switching the
unit in DMX Mode. When there is a signal input, the dot in
A.001 on the display will flash. If there is no signal input, the
dot will remain off.
Master mode
• Sound Active mode: Use the UP/DOWN keys to select
"G.-1-" on the display panel.
• Slow-running Mode: Use the UP/DOWN keys to select G-2
on the display panel.
• Fast-running Mode: Use the UP/DOWN keys to select G-3
on the display panel.
• Blackout Mode: Use the UP/DOWN keys to select G-4 on
the display panel.
Slave mode
• S.-1-: Press the UP/DOWN key, when it displays "S.-1-", that
means it is the first light you have chosen.
• S.-2-: Press the UP/DOWN key, when it displays "S.-2-",
that means it is the second light you have chosen.
• S.-3-: Press the UP/DOWN key, when it displays "S.-3-",
that means it is the third light you have chosen.
• S.-4-: Press the UP/DOWN key, when it displays "S.-4-",
that means it is the fourth light you have chosen.
Note: Usually, a complete set is made up of four lights.
eagletone.com
User's manual english