Function Selection - Mitsubishi Electric CITY MULTI PLFY-P NBMU-E Serie Manuel D'utilisation

7. Other Functions
7.2. Error Codes indication
ERROR CODE
Error Code
Unit No.
If you have entered contact number to be called in the event of a problem, the screen displays this number.
(You can set this up under Function Selection of remote controller. For information, refer to section 8.)
If the ON lamp and error code are both fl ashing: This means that the air conditioner is out of order and operation has been stopped (and cannot
resume). Take note of the indicated unit number and error code, then switch off the power to the air conditioner and call your dealer or servicer.
ERROR CODE
°F°C
°F°C
Error Code
If only the error code is fl ashing (while the ON lamp remains lit): Operation is continuing, but there may be a problem with the system. In this case,
you should note down the error code and then call your dealer or servicer for advice.
* If you have entered contact number to be called in the event of a problem, push the Check button to display it on the screen. (You can set this up un-
der Function Selection of remote controller. For information, refer to section 8.)

8. Function Selection

Function selection of remote controller
The setting of the following remote controller functions can be changed using the remote controller function selection mode. Change the setting when
needed.
Item 1
1. Change Language
("CHANGE LANGUAGE")
2. Function limit
("FUNCTION SELECTION")
3. Mode selection
("MODE SELECTION")
4. Display change
("DISP MODE SETTING")
ON lamp
ON/OFF
(Blinking)
When the Check button is pressed:
CALL:XXXX
XXX:XXX
ON/OFF
Item 2
Language setting to display
(1) Operation function limit setting (operation lock)
("LOCKING FUNCTION")
(2) Use of automatic mode setting ("SELECT AUTO
MODE")
(3) Temperature range limit setting ("LIMIT TEMP
FUNCTION")
(1) Remote controller main/sub setting ("CONTROL-
LER MAIN/SUB")
(2) Use of clock setting ("CLOCK")
(3) Timer function setting ("WEEKLY TIMER")
(4) Contact number setting for error situation
("CALL.")
(1) Temperature display °C/°F setting ("TEMP
MODE °C/°F")
(2) Room air temperature display setting ("ROOM
TEMP DISP SELECT")
(3) Automatic cooling/heating display setting ("AUTO
MODE DISP C/H")
ON/OFF
Item 3 (Setting content)
• Display in multiple languages is possible
• Setting the range of operation limit (operation lock)
• Setting the use or non-use of "automatic" operation mode
• Setting the temperature adjustable range (maximum, minimum)
• Selecting main or sub remote controller
* When two remote controllers are connected to one group, one controller
must be set to sub.
• Setting the use or non-use of clock function
• Setting the timer type
• Contact number display in case of error
• Setting the telephone number
• Setting the temperature unit (°C or °F) to display
• Setting the use or non-use of the display of indoor (suction).air temperature.
• Setting the use or non-use of the display of "Cooling" or "Heating" display
during operation with automatic mode
13