GEL DECAL BASIC Série Notice D'utilisation Et Entretien page 44

13.3 - HOW TO SET REGENERATION TIME AND FREQUENCY
(reserved to Technical Assistance Service)
Once time has been adjusted, by pressing key
where the two left figures on display and the green Led indicating the regeneration time will be flashing.
- Press keys
- Press keys to confirm the regeneration time.
P.S. During regeneration, the water softener does not supply treated water, therefore set the time when
there is no water consumption (by night for civil use).
Repeat the operation to set the regeneration frequency in days (for potable use it is recommended
max. every 4 days) indicated by the two right figures on display, whilst press key
P.S. For potable use, it is recommended to regenerate max. every 4 days, therefore the regeneration
mode needs to be set at volume/ time or at time.
- If you have a Timer ET 500, programming is completed.
- If you have a Timer VT 1000, programming carries on with the following step 13.4.
13.4 - HOW TO SET THE WORKING MODE (TIME – VOLUME – VOLUME/ TIME)
(reserved to Technical Assistance Service)
From the frequency of the regeneration days, by pressing key
and the regeneration priority will be flashing. It can be by:
- Time
- Pure volume
- Volume/ time
- Press key to change the regeneration mode.
- Press key to confirm the regeneration mode.
At this point the timer programming is completed.
44
DUREZZA ACQUA ORA
WATER HARDNESS HOUR
DURETÉ EAU HEURE
SELECT
to modify the regeneration time.
DUREZZA ACQUA ORA
WATER HARDNESS HOUR
DURETÉ EAU HEURE
SELECT
, the display below will be shown
MINUTI ORA RIG GIORNI
MINUTES HOUR REG DAYS
MINUTES HEURE REG JOURS
WASHING MODE
TIME
VOLUME
VOLUME-TIME
the figures on display will disappear
MINUTI ORA RIG GIORNI
MINUTES HOUR REG DAYS
MINUTES HEURE REG JOURS
WASHING MODE
TIME
VOLUME
VOLUME-TIME
to confirm.