GEL DECAL BASIC Série Notice D'utilisation Et Entretien page 36

- For pressures lower than 2 atm. install a pumping system with surge tank.
- For pressures higher than 6 atm. install a pressure reducer.
- After the water meter, install a check valve.
- For potable use a residual hardness of 15° f is recommended, for which the installation of a mixing
valve (manual or automatic) is necessary.
- For potable use the resins disinfection system is recommended (model with initial AD code).
- For the models Decalux Basic 15, 20 and 25, after installation, remove the wooden locks placed
inside the brine tank, keeping the vessel still during transport.
After installation, for start up and testing of the equipment, directly contact your dealer or
installer from whom you have purchased the machine.
Do not use the equipment before the start up and testing carried out by your dealer or
authorized technical staff.
36