Installation - Zanussi ZRB34214XA Notice D'utilisation

Masquer les pouces Voir aussi pour ZRB34214XA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
www.zanussi.com
Possible cause
The door has been opened of-
ten.
The QuickFreeze function is
switched on.
There is no cold air circulation
in the appliance.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
Electrical connection
• Before plugging in, ensure that the voltage
• The appliance must be earthed. The power
• The manufacturer declines all responsibility if
• This appliance complies with the E.E.C.
Open the door only if necessary.
Refer to "QuickFreeze function".
Make sure that there is cold air cir-
culation in the appliance.
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre
and frequency shown on the rating plate
correspond to your domestic power supply.
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
the above safety precautions are not
observed.
Directives.
Solution
53

Publicité

Table des Matières
loading

Table des Matières